MV Accessories (>1...36kV)

A complete range of terminations, joints, separable connectors and equipment bushings up to 42 kV. Terminations and joints are available in heat or cold-shrinkable technologies as well as slip-on. For paper insulated cables, a full range of terminations and joints (including transition joints) is also available. Separable connectors are produced EPDM while equipment bushings are made in epoxy.

• Medium voltage heat-shrinkable terminations and joints
  Suitable for single or 3-cores, paper or polymeric insulated cables up to 36 kV. The high quality heat-shrinkable non-tracking tubes and stress control tubes of the terminations provide long-term performance and the highest reliability for indoor as well as for outdoor applications. The heat-shrinkable joints offer an easy to install and reliable connection. If required, a galvanized steel case can be supplied to protect the joint from external impact and ground pressure.
• Medium voltage cold-shrinkable terminations and joints
  Suitable for single core, paper or polymeric insulated cables up to 36 kV, these cold-shrinkable accessories set new standards in installation technique. All functions are integrated in single piece which is factory installed on plastic supporting tubes. After standard cable preparation, the pre-expanded accessory is positioned over the cable and shrunk by extracting the supporting tubes. Installation is considerably simpler and faster than with any other system presently available.
• Medium voltage slip-on terminations
  Suitable for single core polymeric insulated cables up to 42 kV, this range of pre-molded slip-on terminations is made of silicone rubber. Terminations in silicone-rubber are single pieces and can be used for indoor and outdoor applications.
• Medium voltage slip-on premolded separable connectors
  A range of pre-molded separable connectors are available in EPDM rubber for plug-in or bolted connections up to 36 kV and 1250 A. Available in straight, elbow or "T" versions, these connectors offer a safe to touch connection to switch gear and transformers. Jumpers can be supplied with a combination of connectors and terminations at each end. An EPDM surge arrestor is available.
• Medium voltage epoxy resin equipment bushings
  A large range of equipment bushings for in-oil, in-air or in-gas and for plug-in or bolted versions up to 36 kV and 1250 A. A variety of fixing flanges for different clamping (or welding) systems is available as well as plug-in type epoxy termination.